Needed to print some very special 380mm tall items, so decided to modify my ender 2 to print very tall prints. it works surprisingly well, and the bad resonance only kicks in at about 390mm!
Needed to print some very special 380mm tall items, so decided to modify my ender 2 to print very tall prints. it works surprisingly well, and the bad resonance only kicks in at about 390mm!
I always print slow with it. The tiny heated bed uses so little power, maybe only 5p per hour to run, Vs my rating which was costing me 20-30p per hour :|
Maybe go with independent heater zones on the ratrig? Idk if the cost of multiple new heaters and supporting hardware would be worth it tho