Quick upgrade for easy to plug and unplug end effectors/toolheads. Activity/status LED are also moved from the back of the printer to the top and some more voltage regulation to provide additional voltage rails.

While a nice connector adds significant cost it is also a big value add for certain 3D-printer. I think more manefacturer should consider tiny details like this when designing their product.

Strain relief isn’t installed on this tool for reasons …

  • HumanPenguin@feddit.ukEnglish
    2·
    3 months ago

    Multihead printing is still in the early days.

    Agreed but then so was 3D printing as a whole 10 years ago. It is open source design started by Rep Rap that put us where we are now.

    Im a about to be beginner. Recently retired through disability. So finally have time to play with the subject. So yes, at some point I’d like to come back to you and take you up on your offer. ATM im saving to buy a Elegoo Neptune 4 Pro. And from there I have some projects to do then will start building my own design based on an open design I looked at in the past. (cant remember the name of my head)

    • IMALlama@lemmy.worldEnglish
      2·
      3 months ago

      Rep Rap got started in 2005 and their 1.0 design was released in 2008. This (eventually) spawned the OG Prusa i3, which launched in 2016. I’m not sure that FDM has advanced at ton since then, and I say that as a recent Voron 2.4 builder. Quality of life, absolutely. Tech? It seems more incremental/evolutionary than revolutionary. I’m sure multi-extruder will become better implemented over the next few years, but I’m not sure how far it will wind up going. It doesn’t seem like there’s going to be an elegant solution, which largely just leaves complicated solutions.