Has anybody used one of these mini “dehumidifiers” to dry out filament as a substitute for buying a bunch of the desiccant beads? My filament seems OK, but I could do better to keep it dry.

  • kenblu24@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    The one in OP’s picture is one such device. You plug it directly into the wall and it heats up. No fan though, just passive convection

    • marcos@lemmy.world
      link
      fedilink
      English
      arrow-up
      0
      ·
      1 year ago

      Oh, so the OP’s question is about using recyclable beads instead of single-use ones?

      I though it was a machine that forced air into the beads.

      • Anonymouse@lemmy.worldOP
        link
        fedilink
        English
        arrow-up
        0
        ·
        1 year ago

        I didn’t realize that the desiccant beads were able to be dried out. I thought they were single use. I have a bunch in the bottom of a Rubbermaid tote with a rubber foam sealed lid along with my filament. I don’t know how to tell when the beads are “full” and started thinking about a more recyclable approach. After thinking about it a bit, I should probably get a humidity meter.

        • marcos@lemmy.world
          link
          fedilink
          English
          arrow-up
          2
          ·
          1 year ago

          The ones that are sold for single-use tend to break into pieces when they absorb too much water.

          The ones intended to be reused normally have some mechanism to tell you they are “full”, like changing colors.